AK47 Parts

$19.95
Quality reproduction leather K98 sling.
In stock
+

$59.95
With Y & I Embossing, 1mm
This flat will work with the M92 or M70 that has the flat sided front trunnion . These will NOT WORK with the bulged RPK style trunnions.   There...
Out of stock

$14.95
This is a new design that matches the original plates.  Orders shipped after 9/5/2015 will have the newer design. These are not needed on the Yugo's...
Out of stock

$44.95
With Y & I Embossing, 1mm
Now with Y & I embossing! These flats can be used for about any 1mm thick 7.62 receiver.  Without the trunnion holes you can put any rear...
Out of stock

$45.95
With Y & I Embossing, 1mm
This flat has the magwell and mag dimples to match the 5.45 magazines which are narrower then 7.62 mags.  There are no front or rear trunnion holes....
In stock
+

$59.95
With Y & I Embossing, 1mm
These are the correct flats for the AMD-65 parts kits with the sidefolding stock.  These do not need the sidefolder reinforcement plate.  The...
In stock
+

$59.95
With Y & I Embossing, 1mm
THESE DO NOT HAVE ALIGNMENT HOLES IN THEM ANYMORE The AMMS trunnions I have seen are machined unlike the Polish which are stamped and welded...
Out of stock

$14.95
These new plates have been made from the dimensions of original demilled Russian and Bulgarian plates. This plate welds to the rear lower section of...
In stock
+

$59.95
With Y & I Embossing, 1mm
This flat is specifially made for the Polish Tantal to work with the left side selector and right side safety.  The hole for the selector/safety is a...
In stock
+

$59.95
With Y & I Embossing, 1mm
    These are made to work with the Romanian underfolder stocks and will not work with the Polish or Yugo sets.  There is no need to buy...
In stock
+

$59.95
With Y & I Embossing, 1mm
T h is flat is for using a Bulgarian style rear sidefolding stock/trunnion to make the so called "Khyber Pass" AK's in 7.62x39. Receiver flat...
Out of stock

$57.50
1.5mm
Finally there is an alternative to the home builder to make your own professional grade 1.5mm receiver from a flat.  The material these are made from...
In stock
+